098-00564-000 Revision A3 – July, 2013
TimeProvider 2300/2700 User’s Guide
123
Chapter 3
TimeProvider 2300/2700 CLI Command Set
show ptp
Use this command to display the PTP master and PTP client configuration
information: the active profile selection, and all the parameters under different
profiles, the client list for PTP master, the grand master table for PTP client, and the
status for PTP master and PTP client.
Command Syntax:
PTP MASTER:
To display the the active profile selected for PTP master on the ETH2 port:
show ptp master active-profile eth2
To display PTP master’s configurable attributes under different profiles on the
ETH2 port:
show ptp master config eth2 {telecom-2008 | itu-g8265-1 |
default}
To display the client list of PTP master on the ETH2 port:
show ptp master client-list eth2 {all | clock-id}
To display the status of PTP master on the ETH2 port:
show ptp master status eth2
PTP CLIENT:
To display the active profile selected for PTP client on the ETH1 port:
show ptp client active-profile eth1
To display the status of PTP client on the ETH1 port:
show ptp client status eth1
To display the VLAN attachment for the master(s) of PTP client on ETH1 port:
show ptp client vlan-attach eth1
To display the asymmetry information for PTP client on the ETH1 port:
show ptp client eth1 asymmetry
To display the configuration of network transport type for PTP client on the ETH1
port:
show ptp client config eth1 transport
To display the configuration of the service tier for PTP client on the ETH1 port:
show ptp client config eth1 service-tier
