Symmetricom SDU-2000, User Manual

Page: 305 / 470

12713020-002-2 Revision D – April 2004 SSU-2000 User’s Guide 305
TL1 Command Interface
SET-GPS-POS:[tid]:[aid]:
ctag::[(lat)],[(lon)],
[(hgt)],[pdop],[avg],
[posel],[timel];
Valid aid code:
S1A3
or
S1A5
(must be a GPS module)
This command sets the position mask for the GPS module
designated by the aid.
The settings for this command include:
lat
= set the latitude [
±
90deg], formatted
(DD)-MM-SS.SS, where + = North and – = South
lon
= set longitude [
±
180 deg] formatted as
(DD)-MM-SS.SS, where + = East, and – = West
hgt
= set height [
±
10000.0 meters]
pdop
= set the pdop [1 to 10]
avg
= set position averaging value [10 to 3600]
posel
= set the minimum satellite elevation to use for
positioning [0 to 50 deg]
timel
= set the minimum satellite elevation to use for
timing [0 to 50 deg]
SET-INPUT-REF:[tid]::ctag::
port[,swtmode] [,selmode];
Valid aid code: None
This command sets the current input reference to the
designated input port.
swtmode
= [AR|AS|OFF] for autoreturn (revertive)
selection, autoswitch (non-revertive), or no auto switching
selmode
= reference selection: [PRI|PQL] for priority or
status message selection of inputs
If the input port is not a valid reference, then the DENY
response is returned.
SET-MTIE-MASK:[tid]:[aid]:
ctag::mask;
Valid aid code:
ALL
,
SxAy-[z]
This command will set the MTIE mask for the given input to
predefined settings, such that mask can be set to PRS| DS1|
G811|G823. The MTIE mask settings include both Limit 1 and
Limit 2 and set and clear thresholds. For user defined
thresholds, use the SET-PRMTR-MTIE command.
SET-NAME:[tid]:[aid]:ctag::
name;
Valid aid code: none,
S1A2
, or I/O port
aid
.
This command with no aid or S1A2 (Communications
Module) assigns a new name to the unit. The tid (if used)
must match the original name, which is returned in the
response sid. The new unit name must be used as the tid
(and sid) for all commands following.
For an aid designating an Input or Output port the name is
assigned to the port. The name for unit or port may be null or
as many as 20 characters beginning with a letter.
SET-PHASE-ZERO:[tid]:[aid]:
ctag[::clksrc];
Valid aid code: none or Input port aid.
This command sets the input phase to zero for the designated
port(s) or all input ports with an aid of null or ALL. If clksrc is
specified [CLK-A|CLK-B] only the one phase value is set to
zero; otherwise both values are set to zero.
Table B-6. TL1 Set Commands (Continued)
Command Description