Symmetricom GoWide 4.6, User Manual

Page: 22 / 134

22
GoWide 4.6 G.shdsl Bridge/Router – User Manual
Installation
097-91022-01 Issue 1: February 2002
S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S
2
Figure 4. Change Password Screen
Setting Factory Defaults
The GoWide 4.6 can be set to the Factory Default settings via the reset switch on
the unit’s rear panel (see Figure 2).
To reset the GoWide 4.6, press the reset button and hold down for 5 seconds while
the unit is on.
Once the reset button is released, the unit will restart and the settings will revert to
the factory default settings.
Note:
The mode of operation for the unit, the password, and the unit IP Address
will all be changed to the default settings. If you want to reboot or restart the GoW-
ide 4.6, DO NOT use the reset switch. Use the ON/OFF switch instead.