Symeo LPR
®
-System
LPR
®
-2DB
Product Documentation
Network
Settings
Copyright © Symeo 2012
Page 89 of 132
the SYMEO technical department about this.
If the LPR station is set to „DHCP“ but does not get after
the reboot within 60 sec an IP-address from the DHCP server the last
applied fixed IP-address is used.
Change Mode
A button is labeled "DHCP" or "Static" depending on the "Current mode"
field. Click this button to switch from "DHCP Active" mode to "Static IP-
Address" mode or vice versa.
IP-Address
IP address of the LPR station
(default: 192.168.1.99)
In "DHCP Active" mode, this address is assigned by the server and
cannot be edited.
In "Static IP-Address" mode you can assign a fixed (static) address here.
Netmask
Net mask of the LPR station
(default: 255.255.255.0)
In "DHCP Active" mode, the net mask is assigned by the server and
cannot be edited.
Gateway
IP address of the standard gateway
Other LAN segments can be reached with the standard gateway.
In "DHCP Active" mode this address is assigned by the server and
cannot be edited.
9.3.2
Network
Hostname
Hostname of the system (default: "lprb-basestation").
In "DHCP Active" mode, this hostname is also communicated to the
DHCP/DNS server.
A name that will be reserved on the DNS server can be entered here.
You can also ask your administrator or the SYMEO technical department
about this.
DNS
IP address of the DNS server:
The DNS server is able to translate hostnames into IP addresses.
In "DHCP Active" mode this address is assigned by the server and
cannot be edited.
Syslog
IP address of the Syslog server (default: 0.0.0.0, i.e. this service has
been disabled).
The Syslog server is a server on the network to which it is planned to
have system messages (system log) transmitted. Transmission is packet-
based (UDP) and unencrypted.
NTP
IP address of the NTP server (default: 0.0.0.0, i.e. this service has been
