Symbol SPT 1700, Product Reference Manual

Page: 161 / 317

9-17
Applications: HotSync
Conducting a Wireless HotSync via Spectrum24
Note: This function is available on SPT 1740 ONLY.
The SPT 1740 allows you to perform a HotSync without using a cradle, over the Spectrum24
wireless LAN. This section describes the setup necessary for a wireless HotSync to occur.
Setting Up for a Wireless Spectrum24 HotSync
Before a wireless HotSync can be performed, the SPT 1740 must be properly configured for
use in the Spectrum24 environment. See Chapter 2,
Spectrum24 Setup for specific
instructions on this.
Once the terminal is properly configured for use in the Spectrum24 environment, it must be
setup to perform a wireless HotSync over the Spectrum24 wireless LAN.
1. Tap the icon to open the Applications Launcher.
2. Tap the icon to open the HotSync application.
3. Tap the icon to display the HotSync options menu.
4. To configure the Modem Sync Preferences :
a. Select Modem Sync Prefs.
b. Select “Network” and tap “OK”.
5. To configure the Local Sync Preferences :
a. Select the menu icon to display the options menu.
b. Select Local Sync Prefs.
c. Select LANSync.
d. Tap “OK”.
6. To configure the Primary PC host Setup :
Note: This panel is extremely important! It tells the SPT 1740 terminal how
to locate the machine which it will synchronize with on the network.
a. Select the menu icon to display the options menu.
b. Select Primary PC Setup.
c. Using the PC you will synchronize with most often, right click on the HotSync
Manager in the Windows tray on the host PC. Left click on Setup, click on the
Network tab and then click on the TCP/IP Settings button. Copy down the