5-5
Operating the Series 68XX
Cold-Boot Failure
During a cold boot, the system briefly displays a status line for each driver as it loads in the
format:
0: Driver
#.##
The line shows a status value, usually 0, followed by the name and version number of the
driver. If the system halts at one of these lines and displays a status value other than 0, the
displayed device driver failed to load properly.
If such a failure occurs, try cold booting the terminal again. If this does not solve the problem,
call the Symbol Support Center.
More troubleshooting information is provided in the publications listed in Related
Documentation at the beginning of this manual.
Boot to Command Mode
Command Mode provides functions for:
t
Running the Self-Test program to verify that the hardware is operating properly
(refer to
Chapter 7, Error Recovery and Troubleshooting
t
Performing a Memory Transfer to upload data from a terminal to a host system
(refer to
Chapter 7, Error Recovery and Troubleshooting
t
Performing a Program Download to transfer an application from the host to a
terminal (refer to
Chapter 3, Batch and Spectrum One Terminal Setup
To boot to Command Mode:
1. Power the Series 68XX off.
2. Press and hold down the F and I keys.
3. Press and release the PWR key.
4. Release the F and I keys.
Summary of Contents for Series 6800
