Symbol Series 6800, Product Reference Manual

Page: 43 / 138

3-6
Series 6800 Product Reference Guide
Starting Communications
1. The terminal is ready to receive the program from the host PC and displays:
Comm Parameters
Start? <ENT>
2. Press <ENTER> on the terminal.
3. Press <ENTER> on the host computer. SENDHEX begins transmitting the program
image. When communications are established, the terminal displays:
Program loader
Receiving: XXXX
During program loading, the display shows the program segment address being
transferred (XXXX).
4. When the transmission is complete, the terminal displays:
Program loader
Status 0000
A status of 0000 (all zeros) indicates a successful transfer. Other status values
indicate an error. These values are provided in
Appendix B, Communications Status
Codes .
If you received an error, press <Clear> on the terminal to return to the Command
Mode main menu.
Ending Communications
To return to the Command Mode main menu:
1. Press <Clear> on the terminal.
2. Power down the terminal.
3. Detach any cables connected to the terminal.
4. Reboot the terminal using the appropriate cold boot sequence described in
Chapter
5, Operating the Series 68XX , in the section Booting a Series 68XX.