Symbol PPT 8800, Product Reference Manual

Page: 145 / 328

4-25
Communications
b. Press 1 to enable or 0 to disable Static mode. The Public network settings menu
re-appears with the new Static Mode value.
c. Press 2 to set the NAPT Mode. The NAPT Mode selection appears:
d. Press 1 to enable NAPT or 0 to disable NAPT mode. The Public network
settings menu re-appears with the new NAPT Mode value.
e. Set the DHCP Address Mode as follows:
For the 6 DHCP Address Mode: Set NAPT Mode to 0 (see step c).
When Static Mode and NAPT Mode are both set to 0, the cradle acquires 6 IP
addresses from the DHCP server.
For the 1 DHCP Address NAPT Mode: Set NAPT Mode to 1 (see step c).
When NAPT Mode is set to 1, the cradle uses 5 private NAPT addresses
(192.168.1.1 through 192.168.1.5 by default; the network does not see these
addresses).
f. Press Q to return to the main Cradle Utilities menu.
g. Press F to write these values to flash memory and reset the cradle.
Configuring the Cradle for Static Mode
1. Start a cradle terminal emulation session:
a. Connect the modular end of the cable (p/n 170013-000) and a null modem
adapter between the expansion port of the cradle and a COM port on a host
computer. See
Figure 4-23 on page 4-23 .
b. Start a terminal emulation session on the host computer. Use standard terminal
emulator software, such as Pro-Comm
TM
or Hyperterminal
TM
. Use the following
terminal emulation settings: 115200 bps, 8N1, XON/XOFF flow control, ASCII
file transfer protocol.
c. Power on the cradle. Before the power up LED sequence begins, on the host
computer press “ a ” from the terminal program to load the Cradle Utilities
Enter ‘1’ to enable NAPT mode
Enter ‘0’ to disable NAPT mode
Enter new value: