Symbol PDT 6100, Product Reference Manual, Page: 27 / 108

3-4
PDT 6100 Product Reference Guide
Note: Versions of SENDHEX earlier than 3.0 do not support flow control.
If you use an earlier version and encounter communication errors, use
a lower baud rate. If you use a later version of SENDHEX and have
communications errors, try setting flow control to XON/XOFF.
4. SENDHEX displays the prompt:
Press <ENTER> to begin
communications.
5. Do NOT press <ENTER> yet. Before starting communications (refer to Starting
Communications on page 3-6), set up the PDT 6100 for loading a HEX image as
directed in the following sections.
Initiate Terminal Communications
1. Boot the PDT 6100 to command mode.
For the 22-Key terminal:
"
Press and hold <SEND> and <9>.
"
Press and release PWR .
"
Release <SEND> and <9>.
For the 35-Key terminal:
"
Press and hold <BKSP> and <SHIFT>.
"
Press and release PWR .
"
Release <BKSP> and <SHIFT>.
For the 46-Key terminal:
"
Press and hold <F> and <I>.
"
Press and release <PWR>.
"
Release <F> and <I>.
The display shows the function selector screen:
COMMAND MODE
Select function
Self Test