Symbol P360, Product Reference Manual

Page: 26 / 198

2-6
P460/P360 Memory Scanners Product Reference Guide
The cradle recharges batteries in the scanner only when the scanner is in the cradle. A
scanner with a depleted battery starts charging immediately upon insertion into the cradle,
whereas a scanner with a partially charged battery begins charging after approximately 15
minutes. Note that the scanner can be removed from the cradle at any time.
Charging Using a Cable
1. Connect the cable to the scanner.
2. Connect the power supply to the power jack on the cable.
3. Connect the power supply to a receptacle supplying AC power of the proper
voltage level.
4. The battery charges automatically. A full charge of a depleted battery takes
approximately 3-1/2 hours.
Charging Using the UBC 2000
The battery can be charged using the Universal Battery Charger UBC 2000. The UBC
adapter for the P460/P360/P470/P370 scanner battery is required. Refer to the UBC 2000
guide for information on recharging the battery using the UBC 2000.
Charge Status LED Indications
The LED indicator on the cradle uses flashing patterns to display the charger status, as
shown in the table below.
Table 2-1. Cradle LED Indications
LED Status
Off The scanner is not in the cradle or has not been
properly inserted into the cradle.
Blinking Slowly The scanner is properly seated in the cradle and
charging will begin shortly.
Blinking Rapidly The battery is actively charging.
On Battery charging is complete.