Symbol P360, Product Reference Manual

Page: 164 / 198

5-94
P460/P360 Memory Scanners Product Reference Guide
Beep on <BEL>
When this parameter is enabled, the scanner beeps when a <BEL> character is detected
on the RS-232 serial line. <BEL> is issued to gain a user's attention to indicate an illegal
entry or other important event.
BEEP ON <BEL> CHARACTER
(ENABLE)
*DO NOT BEEP ON <BEL> CHARACTER
(DISABLE)
Intercharacter Delay
Select the intercharacter delay option matching host requirements. The intercharacter
delay gives the host system time to service its receiver and perform other tasks between
characters. The delay period can range from no delay to 99 ms in 1 ms increments (if you
are using a cradle and RTS/CTS handshaking, the delay period can range from 5 ms to 99
ms). After scanning the bar code below, scan two bar codes beginning on page
5-99 to set
the desired time-out. If you make an error, or wish to change your selection, scan
CANCEL on page 5-101. The default time is set to 0.
INTERCHARACTER DELAY