Byte Stream Command List
MR 100 User Manual
Page: 10
MR 100 User Manual
C h a p t e r 4 .
B
Y T E
S
T R E A M
C
O M M A N D
L
I S T
Below is a listing of all commands that are supported by the MR 100 reader. For more information of how to use each
command refer to the Matrics API Programmers Manual.
4.1.
Read Full Field Command (22
hex
)
Read all RFID tags using one antenna port of the addressed reader. With the MR 100 you can use this command to read
tags using the first and only antenna port of the reader. Other antenna ports (2-4) should not be used while using the
command with the MR 100. For more information on this command refer to the Matrics API Programmers Manual.
4.2.
Set Parameter Block Command (23
hex
)
Set parameters related to the first and only antenna port of the address MR 100 reader. For other readers this
command is capable of initializing more than one antenna simultaneously. However, for MR 100 only the first antenna
port must be initialized.
While using this command also ensure that you do not use combination features since MR 100 supports only one
antenna and does not support combination. For more information on this command refer to the Matrics API
Programmers Manual.
4.3.
Get Parameter Block Command (24
hex
)
Get parameters for one specific antenna port. For the MR-100 this command should be used only by passing the logical
indicator of the first (only) antenna in the request packet. For more information on this command refer to the Matrics
API Programmers Manual.
4.4.
Set Node Address Command (12
hex
)
For more information on this command refer to the Matrics API Programmers Manual.
4.5.
Get Reader Status Command (14
hex
)
For more information on this command refer to the Matrics API Programmers Manual.
4.6.
Set Suspend Mode Command (18
hex
)
For more information on this command refer to the Matrics API Programmers Manual.
4.7.
Get Node Address Command (19
hex
)
For more information on this command refer to the Matrics API Programmers Manual.
4.8.
Set Baud Rate Command (1D
hex
)
With MR 100 this commands supports a maximum baud rate of 115200 bps. For more information on this command
refer to the Matrics API Programmers Manual.