Symbol MK2200 MicroKiosk, Product Reference Manual

Page: 28 / 278

1 - 12 MK2200 MicroKiosk for CE .NET 4.2 Product Reference Guide
Specular Reflection
When laser beams reflect directly back into the scanner from the bar code, they can “blind” the scanner and
make decoding difficult. This phenomenon is called specular reflection.
To avoid this, scan the bar code so that the beam does not bounce directly back. But do not scan at too oblique
an angle; the scanner needs to collect scattered reflections from the scan to make a successful decode.
Practice quickly shows what tolerances to work within.
Figure 1-9
Avoiding Specular Reflection
When scanning a 1D bar code, there is only a small specular dead zone to avoid (+ 2
o
from the direct laser
beam). The specular dead zone is larger for scanning PDF417 (+ 9
o
from the direct laser beam). However, the
scanner is not effective if its beams hit the bar code surface at an angle greater than 30
o
.
No specular
reflection.
Decode can occur.
Side Views
Tilt Bar Code At Slight Angle (Up to 30°)
Ba
r C
od
e
Specular reflection.
Reflected beam is
within specular dead
zone and prevents
decode.
30
°
Ba
r C
od
e