Symbol MK2200 MicroKiosk, Product Reference Manual

Page: 190 / 278

B - 2 MK2200 MicroKiosk for CE .NET 4.2 Product Reference Guide
Aegis Client
Install the Aegis Client included in the platform partition 2046c42Plat64Mxxx.hex onto the MK2200 to
implement WPA enterprise wireless security. Wireless MK2200s ship from the factory with this client installed.
Use the Aegis Client to configure the MK2200’s Spectrum24 wireless network settings. See Aegis Client
documentation for more information.
Persisting Aegis Settings
To permanently save the settings configured by the Aegis Client, run
Start > Programs > Tools > Save Aegis
Configuration
. This creates the \Applications\Aegis.reg file containing the configured parameters.
To save certificates installed on the MK2200 for use by Aegis Client, run
Start > Programs > Tools > Save
Certificates
. This preserves the certificate across cold boot cycles.
Using Certificates with Aegis Client
When the MK2200 is operating with the default system time after a cold boot (1st of June 1999 12:00:00 AM)
and cannot update its time over SNTP because it is not connected to the network, perform the following to use
certificates with Aegis:
1.
Manually set the date and time.
2.
Install the certificate.
3.
Create a bat file, e.g.,
SetDate.bat
, as follows:
date mm-dd-yyyy
time hh:mm:ss
4.
Create a folder named
StartUp
in the
Application
folder, and copy this bat file to it.
5.
Use Aegis to connect to the required network with the installed certificate.
6.
Select
Start > Programs > Tools > Save Certificates
and
Start > Programs > Tools > Save Aegis Configuration
to save them over power cycles.
IP Configuration of Aegis Client
The Aegis Client does not provide an interface to configure IP settings applicable for NETWLAN adapter. To
configure IP settings, on the MK2200, select
Start > Settings > Network & Dial-up Connections > NETWLAN
and
set the configurations. Then select
Start > Programs > Tools > Save Aegis Configuration
to preserve the settings
over cold boot cycles.
NOTE
To deploy the same Aegis settings on multiple MK2200 devices, copy the Aegis.reg file to
other MK2200 devices.