Symbol MK2000 MicroKiosk, Product Reference Manual

Page: 39 / 194

2-9
Installation
Power
The MK2000 power can be supplied by using the Symbol approved universal AC power
supply or by using Symbol’s BiasT, the Power-over-Ethernet option.
AC Power Supply Connection
The MK2000 can be powered by the Symbol approved universal AC power supply plugged
into the power port on the rear of the MK2000 via a 2.0mm barrel jack. The power supply
has a positive center pin and the outer tab is ground, it is compatible with:
• 120V 60Hz (North America)
• 230V 50Hz (International excluding Japan)
• 100V 50/60Hz (Japan).
To connect the Symbol approved universal AC power supply:
1. Insert the power supply’s barrel connector into the MK2000’s power port, see
Figure 1-3 on page 1-5.
2. Route the power cable, see Figure 1-3 on page 1-5.
3. Plug the Symbol approved AC power supply into a wall outlet.
4. When the power installation is completed, return to Installation Overview on page
2-2 and proceed with step 3 Select the data communications method.
Power-Over-Ethernet Connection
The Ethernet cable in the Power-over-Ethernet (POE) installation has two components,
power and data. The Ethernet cable can be used only to supply power, it can be used only
to supply data or it can be used to supply both power and data.
Power Connection (Attach the Ethernet cable):
• Connect the Ethernet cable to the Ethernet port on the MK2000, see Figure 1-3 on
page 1-5 for port locations. Ensure the Ethernet cable is terminated according to
the Ethernet / Bias-T Port Connections described in Table 2-2.
• Plug the other end of the Ethernet cable into the POE Bias-T module.
• If Ethernet cable will be supplying both power and data, proceed to step 2. If
Ethernet cable will only be supplying power proceed directly to step 3.
Data Connection:
Connect a patch cable from the Bias-T (Power-over-Ethernet) module to the host system’s
Ethernet port.