Symbol MK2000 MicroKiosk, Product Reference Manual

Page: 30 / 194

1-14
MK2000 MicroKiosk Product Reference Guide
Specular Reflection
When laser beams reflect directly back into the scanner from the bar code, they can “blind”
the scanner and make decoding difficult. This phenomenon is called specular reflection.
To avoid this, scan the bar code so that the beam does not bounce directly back. But don’t
scan at too oblique an angle; the scanner needs to collect scattered reflections from the
scan to make a successful decode. Practice quickly shows what tolerances to work within.
Figure 1-9. Avoiding Specular Reflection
When scanning a 1D bar code, there is only a small specular dead zone to avoid (+ 2
o
from
the direct laser beam). The specular dead zone is larger for scanning PDF417 (+ 9
o
from
the direct laser beam). However, the scanner is not effective if its beams hit the bar code’s
surface at an angle greater than 30
o
from the normal to that surface.
No specular
reflection.
Decode can occur.
Side Views
Tilt Bar Code At Slight Angle (Up to 30°)
B
a
r
C
o
d
e
Specular reflection.
Reflected beam is
within specular dead
zone and prevents
decode.
30
°
Ba
r C
od
e