Symbol LS 3408, Product Reference Manual

Page: 261 / 432

Advanced Data Formatting 14-5
The following rules need to be entered:
When scanning data of code type Code 128, send the next 5 characters, send the manufacturer
ID key <CTRL M>, send the next 5 characters, send the part number key <CTRL P>, send the next
2 characters, send the destination code key <CTRL D>.
When scanning data of code type UPC/EAN, send all data, send the manufacturer ID key <CTRL
M>.
To enter these rules, follow the steps below:
Rule 1: The Code 128 Scanning Rule
Step Bar Code On Page Beep Indication
1 Begin New Rule 14-9 High High
2 Code 128 14-12 High High
3 Send next 5 characters 14-28 High High
4 Send <CTRL M> 14-55 High High
5 Send next 5 characters 14-28 High High
6 Send <CTRL P> 14-56 High High
7 Send next 2 characters 14-27 High High
8 Send <CTRL D> 14-54 High High
9 Save Rule 14-9 High Low High Low
Rule 2: The UPC Scanning Rule
Step Bar Code On Page Beep Indication
1 Begin New Rule 14-9 High High
2 UPC/EAN 14-14 High High
3 Send all remaining data 14-27 High High
4 Send <CTRL M> 14-55 High High
5 Save Rule 14-9 High Low High Low
In case of errors while entering this rule, scan the Quit Entering Rules bar code on page 14-10. If
the rule is already saved, scan the Erase Previously Saved Rule bar code on page 14-10.