Symbol LS 3408, Product Reference Manual

Page: 164 / 432

LS 3408 Product Reference Guide 9-10
Convert All Bar Codes to Code 39
By default, the Wand Emulation Interface sends data to the attached host in the same symbology that
was decoded. This may present a problem for customers with older systems that do not recognize
some newer symbologies (for example, RSS).
Enabling this parameter ignores the original symbology that was decoded, and outputs the data as if
it were a Code 39 bar code. Any lowercase characters that were in the original data stream are
transmitted as uppercase characters. This also allows ADF Formatting to occur.
If Ignore Unknown Characters is enabled, any characters that do not have a corresponding
character in the Code 39 symbology set are replaced by a space.
If Ignore Unknown Characters is disabled, if any characters that do not have a corresponding
character are encountered, the scanner emits an error beep and no data is transmitted.
ADF Note: By default, the Wand Emulation Interface does not allow scanned data to be processed by
ADF rules. Enabling this parameter has the side effect of allowing the scanned data to be processed
by the ADF rules (
Chapter 14, Advanced Data Formatting ).
.
Convert to Code 39 for Wand Host
(Enable)
*
Do Not Convert to Code 39 for Wand Host
(Disable)