Symbol Hotspot LS 2100, Product Reference Manual

Page: 250 / 350

13-27
Advanced Data Formatting
Setup Field(s)
Table 13-1. Setup Field(s) Definitions
Parameter Description Page
Move Cursor
Move Cursor To a Character
Scan the Move Cursor To Character
bar code
on page 13-28
, then any printable ASCII
character from the Alphanumeric Keyboard .
When this is used, the cursor moves to the
position after the matching character. If the
character is not there, the rule fails and ADF
tries the next rule.
13-28
Move Cursor to Start of Data
Scan this bar code to move cursor to the
beginning of the data.
13-28
Move Cursor Past a Character
This parameter moves the cursor past all
sequential occurrences of a selected character.
For example, if the selected character is ‘A’,
then the cursor moves past ‘A’, ‘AA’, ‘AAA’, etc.
Scan the
Move Cursor Past Character
bar
code on page 13-28
, then select a character from
the Alphanumeric Keyboard . If the character is
not there, the cursor does not move (i.e., has no
effect).
13-28
Skip Ahead “N” Characters Scan one of these bar codes to select the
number of positions ahead you wish to move
the cursor.
13-29
Skip Back “N” Characters
Scan one of these bar codes to select the
number of positions back you wish to move the
cursor.
13-31
Send Preset Value Send Values 1 through 6 by scanning the
appropriate bar code. These values must be set
using the prefix/suffix values in
Table 6-4 on
page 6-22 .
Value 1 = Scan Suffix
Value 2 = Scan Prefix
13-33