3-23
FMT 3000 Hardware Reference Guide - Option Installation and Operation
The box containing the PC/104 VGA option card also includes a ribbon adapter cable for
converting the 10-pin rectangular video connector on the card to a standard DB15 connector
for a VGA monitor. A user manual for the VGA card is also shipped with the VGA option.
Before installing the card, turn off or remove power to the unit.
Caution
Failing to turn off the power when inserting or removing boards may dam-
age the unit.
To install the PC/104 VGA card:
1. Unlock and open the unit’s case.
2. Align the two rows of PC/104 headers on the card directly over the dual row PC/104
connector (J4) on the unit. Make sure all pins on the card properly align with the
holes on the connector J4.
3. Gently push the card in place until the bottom of the card rests on top of the stand-
off posts installed (at the factory) on the CPU board.
4. Locate the small bag containing 4 screws (G) and 4 small fiber washers (H) in the
installation kit.
5. Secure the VGA card to the stand-off posts using the washers and screws.
6. Install the video out ribbon cable and the power cable into the Ferrite Filter clamp
(D) supplied in the installation kit as shown in
on page 3-21.