3-3
FMT 3000 Hardware Reference Guide - Option Installation and Operation
Mounting Options
If the unit will lay flat for table top use, replace the four foam pads on the back of the unit’s
metal base pan with the four supplied adhesive backed rubber feet (L).
To mount the unit using one of the three mounting bracket hardware options, (Flat Wall
Mounting Bracket, the Tilt Wall Mount Enclosure or the Desk Stand mounting option ),
install 3 of the bracket mounting screws (K) at the locations shown in Figure 3-1. Using a
Phillips head screw driver, turn the screws into the screw holes until they stop. The head of
each screw will protrude a short distance from the surface of the base pan to allow for
insertion into the three mounting slots found on each mounting option.
Figure 3-1. Installing Rubber Feet for Table Top use and Installing Bracket Mounting
Screws for Mounting Option Use
Flat Wall Mounting Bracket
This mounting bracket mounts the unit on a vertical surface using 4 bolts, screws or toggle
bolts (not supplied), depending on the mounting surface.
To mount the unit to the wall mount bracket, insert the 3 Phillips panhead mounting bracket
screws (K) (supplied in the installation kit) in the unit’s metal base pan (see
on page
3-4). The heads of these screws slide into the key-hole shaped slots on the bracket.
Lock down the unit by inserting the remaining screw (K) (supplied in the installation kit)
through the metal base pan to the wall bracket when the case is open.
Foam Pad
Adhesive Backed
Bracket Mounting Screws
For Table Top use:
Remove Foam Pads and
replace with Adhesive Backed
Rubber Feet.
For Mounting Option Use:
Do not remove Foam Pads and
install Phillips Head Mounting Bracket
Screws at locations shown. Turn screws
until they stop (screw heads will protrude).
Rubber Feet