Symbol FMT 3000, Hardware Reference Manual, Page: 28 / 124

2-5
FMT 3000 Hardware Reference Manual - Installation
Figure 2-2. Adhesive Sealing Pad Location
Powering the Unit
Power plugs into the unit at connector P4 on the unit’s Power I/O board using the 2 position
terminal block connected to the power supply (see the top portion of
Figure 2-3 on page 2-7).
Note: An additional 2 position screw type terminal block is provided in the
installation kit bag to connect power from another source.
The polarity of the power connection makes no difference since the power is internally
rectified by the power board. Power options are shown in the lower half of
Figure 2-3 on
page 2-7.
1. Remove the cable cut-out cover on the back of the unit and store it for possible later
use.
Foam Pads
Cable Tie Holder
Cable Tie
Cable Access Hole