Symantec Security 5600 Series, Security 5400 Series,Clientless VPN 4400 Series, Administration Manual

Page: 106 / 861

106 Maintaining your security gateway
Making system changes with the System Setup Wizard
11
Click Next .
12 In the Confirmation panel, scroll to Network interfaces to review the summary the new network
interface.
13 Click Finish .
A message tells you that the security gateway will be rebooted in 30 seconds and asks if you want to
reboot immediately
14 If you do not want to wait for the reboot to start, click OK .
The Symantec Gateway Security 5000 Series v3.0 logon dialog box displays and the security
gateway reboots.
When the reboot has completed, you can log on to the SGMI again.
15 After adding the network interface, you can use it in the following ways:
■
In rules, as the point where traffic arrives at or leaves the security gateway
■
In clientless VPN profiles, as the location of the DHCP server
■
In host and subnet network entities, as the spoof protected interface
■
In security gateway network entities, to identify the security gateway
■
In redirected services, as the requested address
■
In address transforms, as the point where traffic arrives at or leaves the security gateway
Related information
For further information related to this topic, see the following:
■
“System Setup Wizard” on page 795
■
“Adding a network interface to a cluster member” on page 525
■
“Creating basic rules” on page 273
■
“Defining VPN profiles to allow communication between the security gateway and clientless
users”
on page 413
■
“Defining traffic endpoints with network entities” on page 160
■
“Configuring redirected services” on page 364
■
“Controlling IP addresses with address transforms” on page 359
Adding VLAN interfaces
To add VLAN interfaces, you run the System Setup Wizard.
Prerequisites
None.
To add VLAN interfaces
1
In the SGMI, in the Tools menu, click System Setup Wizard .
2 In the System Setup Wizard welcome panel, click Next .
3 In the Optional Features panel, click Next .
4 In the Setup Options panel, do one of the following:
■
To add a VLAN interface to an appliance that is not part of a cluster, click Standalone
gateway .
■
To add a VLAN interface to an appliance that is part of a cluster, click Cluster member .
5
Click Next .
6 In the Machine Settings panel, click Next .