Symantec RP-S500, Quick Start Manual, Page: 4 / 6

RP - S500
4
Reporter
Quick Start Guide

Follow the on-screen prompts to generate and down -
load the license file.

Host the license file on an HTTP server that is accessi -
ble by the appliance.
2. Open a terminal emulation program and log in to the ap -
pliance.
NOTE: Confirm the appliance’s DB9 Serial port is con -
nected to a serial terminal or workstation and that the ter -
minal emulation software is configured as in Perform the
Initial Configuration .
3. When prompted with the Serial Console welcome
screen, to access CLI, press: 1
4. To access privileged commands, enter:
enable
5. To download and install the license, enter:
download-from license_file_location
The location must be an HTTP or HTTPS server. FTP
and SCP are not supported.
6. Exit CLI.
NOTE: After the license has been successfully installed,
wait at least one minute for services to start before
attempting to log in to the Management Console window.
6 — Verify Connectivity
Once the appliance has been initialized and licensed, verify
you can log in to the appliance’s Management Console
window.
To log in to the appliance’s Management Console window:
1. Open a browser and enter the appliance’s IP address
and port number. For example, an IP address of
192.168.2.42 with a port number of 8082 (the default),
would be: https://192.168.2.42:8082
2. When prompted, enter the admin Username and Pass -
word , then click Login . The Management Console win -
dow opens.
7 — Perform a Graceful Shutdown
Before mounting the appliance, log in to CLI and perform a
graceful shutdown of the appliance.
To perform a graceful shutdown:
1. Open a terminal emulation program and log in to the
appliance.
NOTE: Confirm the appliance’s DB9 Serial port is con -
nected to a serial terminal or workstation and that the ter -
minal emulation software is configured as in Perform the
Initial Configuration .
2. When prompted with the Serial Console welcome
screen, to access CLI, press: 1
3. To access privileged commands, enter:
enable
4. When prompted, enter the enable Password specified
during the initial configuration.
5. Enter: shutdown
WARNING! Do not power off the appliance with the soft pow -
er switch or by removing the power cables! Abruptly removing
power can result in irreparable data loss. Always use the
shutdown command from CLI to power off the appliance.
8 — Mount the Appliance
The slide-rail kit included with the appliance allows it to be
mounted in a 4- or 2-post equipment rack. The slide-rail kit
includes the following parts:
The slide-rail kit included with the appliance allows it to be
mounted in a 4- or 2-post equipment rack. The slide-rail kit
includes the following parts:
Item
(2) Front brackets
(2) Inner rails
(2) Rear brackets
(4) Middle brackets
(8) M6x13 screws
(8) M6 cage nuts
(10) M4x5L screws
(4) M4x4L screws
RP-S500 Rail Kit