2. Maintenance Information
2-14
Battery
Battery Removal
Remove right cover. (3 screws)
Battery cables removal:
1. At first, remove the negative “-” cable.
2. Then, remove the positive “+” cable.
3. Remove the battery.
If there is some rust on battery posts, clean it
with steel brush.
Install the battery in the reverse procedures of
removal.
Caution
Headlamp Adjustment
Headlamp adjustment
Remove the front fender.
Turn the headlamp adjustment screw to adjust
headlamp beam height. (C.W. is for increasing
beam height, and C.C.W. is for decreasing beam
height)
Reinstall the front fender.
Caution
Nuts, Bolts Tighteness
Perform periodical maintenance in accord with
the Periodical Maintenance Schedule.
Check if all bolts and nuts on the frame are
tightened securely.
Check all fixing pins, snap rings, hose (pipe)
clamps, and wire holders for security.
•
To adjust the headlamp beam follows
related regulations. Do not adjust it
arbitrarily if not necessary.
•
Improper headlamp beam adjustment will
make in coming driver dazzled or
insufficient lighting.
•
If there is rust on the posts very serious,
spray some hot water on the posts.
Then, clean it with steel brush so that
can remove rust for more easily.
•
Apply some grease on the posts after
rust removed to prevent from rust again.
Headlamp adjustment screw
