Operating elements
1
2
3
Location
• To optimize charging, place the solar panel
(2)
in a location exposed to maximum sunlight. Do not set up
the solar panel in the shade or under any cover.
• Do not install the product in the direct proximity of other light sources such as yard or street lights, other-
wise the product will not switch on automatically at nightfall.
• The product is suitable for use in unprotected outdoor areas. Do not submerge!
Mounting
This product comes with a wall mount kit and is designed to be mounted on wall.
When drilling or tightening screws, make sure there are no cables, wires, or pipes located un-
derneath the surface. Inadvertently drilling through electric cables can cause life-threatening
electric shock!
Check if the supplied screws are suitable for the mounting surface material. If in doubt consult a
professional.
When attaching the lamp case to the house number plate, make sure make sure no moisture
enters and the cable connection is not damaged.
1. Select a suitable wall surface (e.g. near a house door).
According to two screw holes on the house number
plate
(3)
, mark two spots on the wall.
2. Using a drill, bore two holes on the marked spots.
3. Correctly orientate the plate: the front side faces out-
ward and the protruding edge faces upward.
Then secure two supplied dowels into the two drilled
holes, and secure two supplied screws into the two
dowels separately.
4. Attach the lamp case
(1)
onto the house number plate
as shown below. It should “click” into place.
5. Gently adjust the lighting angle as shown below.
For your house number, select numbers and/or letters from the supplied stickers and paste them
on the plate.
Solar charging
When using for the first time or after prolonged periods of low sunlight, you should fully recharge the battery.
Operation
For first time use, remove the battery insulation strip. See section “Operation - a) First time use
and light on”.
a) First time use and light on
This product comes with a battery installed. For first time use, you must remove the battery insulation strip
to activate the power supply.
• Find the battery insulation strip on the bottom of the lamp case
(1)
and simply pull it out of the battery
compartment.
b) Notes on battery use and charging
• The batteries can be fully charged for eight hours in sunny weather, which can light the product for ap-
proximately eight hours.
•
Keep the solar panel clean. Dust and dirt covering the solar panel reduces charging efficiency.
•
During extended periods without sufficient sunlight (especially in winter), the rechargeable battery charg
-
es less energy during the day than the lights use at night. So it is possible that the rechargeable battery’s
charge state will only light the product for a brief time only.
• Cold temperatures adversely affect the battery life. To ensure long, error-free operation, we recommend
storing the product in a dry, warm location when not in use.
• You can remove the rechargeable batteries before storing the product and charge them with a suitable
charger. Observe all relevant information provided in these operating instructions regarding removing or
replacing the rechargeable batteries.
1 Lamp case
2 Solar panel
3 House number plate
Front side facing outward
Operating Instructions
Solar House Number Light
Item No. 2338750
Intended use
The product is intended to illuminate a house number which is pasted on the supplied house number plate.
2 LEDs serve as the illuminant. The light turns on automatically at nightfall. The product is powered by two
batteries that recharge via the integrated solar panel during the daylight hours.
The product has an IP44 ingress protection rating. It is splash proof and suitable for outdoor use. Do not
submerge!
For safety and approval purposes, you must not rebuild and/or modify this product. If you use the product
for purposes other than those described above, the product may be damaged. In addition, improper use can
result in short circuits, fires or other hazards. Read the instructions carefully and store them in a safe place.
Make this product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All company names and prod-
uct names are trademarks of their respective owners. All rights reserved.
Delivery content
• Solar house number light (2x rechargeable batteries inserted)
• 1x house number plate
• 2x screws
• 2x dowels
• 2x number stickers
• 1x letter sticker
•
Operating instructions
Up-to-date operating instructions
Download the latest operating instructions at www.conrad.com/downloads
or scan the QR
code shown. Follow the instructions on the website.
Explanation of symbols
The symbol with the exclamation mark in the triangle is used to indicate important information in
these operating instructions. Always read this information carefully.
This product is constructed according to protection class III.
The arrow symbol indicates special information and advice on operation.
Safety instructions
Read the operating instructions carefully and especially observe the safety information.
If you do not follow the safety instructions and information on proper handling in this
manual, we assume no liability for any resulting personal injury or damage to property.
Such cases will invalidate the warranty/guarantee.
a) General information
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become dangerous playing
material for children.
•
Protect the product from extreme temperatures, strong jolts, flammable gases, steam and
solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and protect it
from any accidental use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height can dam-
age the product.
• Do not short circuit the battery terminals
• Consult an expert when in doubt about the operation, safety or connection of the product.
•
Maintenance, modifications and repairs must only be completed by a technician or an au
-
thorised repair centre.
• If you have questions which remain unanswered by these operating instructions, contact our
technical support service or other technical personnel.
b) LED light
• Attention, LED light:
- Do not look directly into the LED light!
- Do not look into the beam directly or with optical instruments!
c) Rechargeable batteries
• Correct polarity must be observed while inserting the rechargeable battery.
• The rechargeable batteries should be removed from the device if it is not used for a long
period of time to avoid damage through leaking. Leaking or damaged rechargeable batteries
might cause acid burns when in contact with skin, therefore use suitable protective gloves to
handle corrupted (rechargeable) batteries.
•
Rechargeable batteries must be kept out of reach of children. Do not leave rechargeable bat
-
teries lying around, as there is risk, that children or pets swallow them.
•
Rechargeable batteries must not be dismantled, short-circuited or thrown into fire. Never re
-
charge nonrechargeable batteries. There is a risk of explosion!
