SPEEDCUT 50
SPEEDCUT 50
SPEEDCUT 50 OPERATING MANUAL
10
SERVICE
8.0 General Maintenance
Each Use
Weekly
3 Months
6 Months
Visual Check of torch tip
and electrode.
Visually inspect the torch body
tip, electrode, start cartridge and
shield cup and torch lead.
Clean exterior of power source
with a dry brush.
Unplug the power source remove cover and visually
check and carefully clean the interior without
touching any internal electrical components wires
or boards.
Inspect the internal filter regulator/filter for contamination
remove and clean if needed.
NOTE: Never use any alcohol based cleaners to clean
filter or assembly use warm mildly soapy water to clean
catchment and rinse throughly. Replace filter if necessary.
Warning!
There is extremely dangerous voltage, and power levels present inside this
product. Do not attempt to open or repair unless you are a qualified electrical
tradespersons and you are qualified in training in power measurements and
troubleshooting techniques. If major complex sub-assemblies are faulty, then the
Cutting Power Source must be returned to an accredited service provider.
