14
Screen Saver
Under Screen Saver, a selection list is presented to you with the following options:
Enable: Screen saver is enabled.
Disable: Screen saver is disabled.
A bullet point is shown next to the currently active setting. Use the encoder wheel to select the desired setting and
push [OK] in order to apply the setting.
Please refer to the section Screen Saver on page 16 for more details about the behaviour of the screen saver.
Mute LEDs
Under Mute LEDs, a selection list is presented to you with the following options:
Mute: All status indicator LEDs of the device remain dark regardless of the device’s status.
Unmute: The status indicator LEDs behave as described under Status LEDs on page 15.
A bullet point is shown next to the currently active setting. Use the encoder wheel to select the desired setting and
push [OK] in order to apply the setting.
Device Information
The following information about the device is available under Home > Menu > Device Settings > Device Information.
Model
The device model is reported as “XND-4” for all variants of the XND-4.
Boot Software
The full version number of the boot software.
Firmware
The full version number of the firmware.
Hardware
The hardware revision.
MAC Address
The MAC address of the node’s Ethernet interface.
Restore Default Settings
The default settings can be restored under Home > Menu > Restore Default Settings. In this menu, you will be asked
whether you want to continue restoring all settings. Push [OK] to confirm or [Cancel] to abort.
This function will restore all settings to the defaults:
Name: SWISSON XND-4
Short name: XND-4
Art-Net net: 0
Art-Net sub-net: 0
All outputs enabled
Art-Net universe output 1-4: 0-3
Failure behaviour (all outputs): Hold last look
Merge mode (all outputs): HTP
IP address: 2.X.Y.Z (primary Art-Net IP address)
