6
First Steps
Aton CL700 IP / Swisscom EN / A31008-M1713-F161-1-2X43 / starting.fm / 27.9.06
Ve
rs
ion 4,
16
.09.
2005
Closing the battery cover
¤
First, align the notches on the side of
the battery cover with the protrusions
on the inside of the housing.
¤
Then press the cover until it clicks into
place.
Opening the battery cover
¤
If fitted, remove the belt clip.
¤
Place your finger in the headset socket
cavity and pull the battery cover
upwards.
Connecting the charging cradle
Connecting the charging cradle is
described at the end of this user guide.
¤
To charge the batteries, leave the hand-
set in the charging cradle.
Initial charging and discharging of
batteries
Battery charging is indicated in the top
right of the display by a flashing battery
icon
e
,
V
or
U
. During handset oper-
ation, the battery icon indicates the
charge status of the batteries (page 1).
The correct charge status can only be dis-
played when the batteries are first fully
charged
and
discharged through use.
¤
To do this, leave the handset in the
charging cradle without interruption
until the battery icon stops flashing in
the display (approx. 13 hours).
¤
Once the batteries are fully charged,
remove the handset from the charging
cradle and do not put it back again until
the batteries are fully discharged.
Please note:
u
Always repeat the charging and dis-
charging procedure if you remove the
batteries from the handset and reinsert
them.
u
The batteries may warm up as they are
charging. This is not dangerous.
u
After a while the charge capacity of the
batteries will decrease for technical rea-
sons.
Notes:
– Only place the handset in the charging cra-
dle that is intended for it.
– If the handset has turned itself off because
the batteries are flat and if it is then placed
in the charging cradle, it will turn itself on
automatically.
Note:
After the first battery charge
and
discharge,
you may replace your handset in the charging
cradle after every call.
Note:
You will find explanations for the icons and
typographical conventions used in this user
guide in the detailed user guide for your
Aton CL700 IP (page 5).