42
Aton CL401 ISDN / SWZ-EN / A31008-M395-F151-1-2X19 / registr_sett.fm / 7.5.08
Ve
rs
ion 4,
16
.09.
2005
Using a handset as a
room monitor
If the room monitor is activated, a previ-
ously saved destination number is called
as soon as a set noise level is reached. You
can save an internal or external number in
your handset as the destination number.
All of the handset keys are deactivated,
with the exception of the display keys.
The room monitor call to an external
number stops after around 90 seconds.
The room monitor call to an internal
number (handset) stops after approx. 3
minutes (depending on the base station).
When the room monitor is activated,
all keys are locked except the end call key.
The handset's speaker is muted.
When the room monitor is activated,
incoming calls to the handset are indi-
cated
without a ringer
and are only
shown on the screen. The display and key-
pad are not illuminated and advisory
tones are also turned off.
If you accept an incoming call, the room
monitor is suspended for the duration of
the call, but the function
remains
acti-
vated.
If you deactivate then reactivate the hand-
set, the room monitor remains activated.
Activating the room monitor and
entering the destination number
v
¢
í
¢
Room Monitor
¤
Change multiple line input:
Room M.:
Select
On
to activate.
Call to:
External number:
Select the number
from the directory (press display key
Ò
) or enter it directly.
Internal number:
§Options§
¢
INT
¢
§OK§
¢
s
(select handset or
Call All
if all registered handsets are to be
called)
¢
§OK§
.
A message and the last four digits of
the destination number or internal des-
tination number are displayed in the
idle status.
Level:
Set noise level sensitivity (
Low
or
High
).
¤
Press
§Save§
to save the settings.
Warning!
– Please note that the "room monitor" does
not function in certain situations, e.g. if
the mobile phone number specified by
the user is busy or has no reception, if
the mains power supply fails or if batter-
ies are empty.
–
You should always check the operation
of the room monitor before use. For
example, test its sensitivity. Check the
connection if you are diverting the room
monitor to an outside number.
– When the function is switched on, the
handset's operating time is considerably
reduced. If necessary, place the handset in
the charging cradle. This ensures that the
batteries do not run down.
– Ideally the handset should be positioned 1
to 2 metres away from the baby. The micro-
phone must be directed towards the baby.
– The connection to which the room monitor
is forwarded must not be blocked by an
activated answer machine.
