57
Appendix
Gigaset C300-C300A / Swisscom EN / A31008-M2203-F151-1-2X19 / appendix.fm / 17.06.2010
V
e
rsion 4, 16.0
9
.2005
Aton CLT112 only:
Approval
This device is intended for analogue tele-
phone connection in the Swiss network.
Country-specific requirements have been
taken into consideration.
If you have any questions about the differ-
ences between the public phone networks,
please contact your specialist dealer or net-
work provider.
Swisscom hereby declare that this device
meets the essential requirements and other
relevant regulations laid down in Directive
1999/5/EC.
The Declaration of Conformity can be found
on the following website:
Appendix
Caring for your telephone
Wipe the unit with a
damp cloth
or an
anti-
static cloth
. Do not use solvents or microfi-
bre cloths.
Never
use a dry cloth. This can cause static.
Contact with liquid
If the handset should come into contact with
liquid:
1. Switch the handset off and remove the
batteries immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open and
the keypad facing down in a dry, warm
place
for at least 72 hours
(
not
in a mi-
crowave, oven etc.).
4.
Do not switch on the handset again un-
til it is completely dry.
When it has fully dried out, you will usually
be able to use it again.
No time is specified for a message in the call list.
Date and time have not been set.
¥
Set the date/time (
The answering machine announces, "PIN is
incorrect" during remote operation.
1. You have entered the wrong system PIN.
¥
Enter the system PIN again.
2. The system PIN is still set to 0000.
¥
Set the system PIN to something other
than 0000 (
The answering machine is not recording any
messages/has switched to answer only mode.
Its memory is full.
¥
Delete old messages.
¥
Play back new messages and delete.
Exclusion of liability
Some displays may contain pixels (pic-
ture elements), which remain activated or
deactivated. As a pixel is made up of three
sub-pixels (red, green, blue), it is possible
that pixel colours may vary.
This is completely normal and does not
indicate an error.
!
