Patent pending. Made in China. TRANSFORMER
®
is a
registered trademark,
MMMMMMMMI
™ and
MI
™ are
trademarks of Swiss+Tech Products. Specifications are
subject to change without notice.
©2011 Swiss+Tech Products, Solon, OH 44139 USA
This product contains button batteries.
IF SWALLOWED,
batteries could cause
severe injury or death in just 2 hours.
SEEK MEDICAL ATTENTION IMMEDIATELY.
• Always purchase the correct size and
grade of battery most suitable for the
intended use.
• Clean the battery contacts and also those
of the device prior to battery installation.
• Ensure the batteries are installed
correctly with regard to polarity (+ and -).
• Remove used batteries promptly.
• Replace all batteries of a set at the
same time.
BATTERY WARNINGS:
Limited LIFETIME Warranty
This product is covered by a Limited Lifetime Warranty
to the original purchaser in that this product is free from
defects in workmanship and materials. During the
warranty period, this product will either be repaired or
replaced with a product of equal or greater value,
excluding any custom engraving or printing.
Damage through normal wear and tear (including
battery expiration and surface coatings), repair or
alteration, misuse, abuse, neglect, accident, improper
storage and handling, fire, negligence, improper
cleaning, circumstances not directly attributable to
manufacturing defects, or act of God is not included.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED
TO, IMPLIED WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR USE.
This warranty gives you specific legal rights, and you
may also have other rights which vary from state to
state. Simply return your SWISS+TECH
®
brand product
postpaid and insured to:
Swiss+Tech Products
30725 Solon Industrial Pkwy
Solon, OH 44139 USA
Transformer
®
6-in-1
Battery Replacement
1. Loosen captive screw (remains in battery
cover). Remove battery cover.
2. Remove old batteries.
3. Replace with two new CR1025 3V lithium
batteries or equivalent with positive (+) and
negative (–) sides positioned as indicated.
4. Replace battery cover. Tighten screw gently.
Flashlight Use
Slide flashlight switch toward LED bulb to turn
on, slide back to turn off.
Screwdriver Use
Press the round, red Lock/Release button to
release the Metal Screwdriver Assembly.
Using fingertip, rotate out 180 degrees until
the Assembly locks into place. This also
releases the Transformer
®
from the Key Ring.
Select the screwdriver you want to use, rotate
it out 180 degrees until it snaps in place.
To close, follow these instructions in reverse.
Re-attach key ring before closing Metal
Screwdriver Assembly
www.swisstechtools.com
1-800-414-8799
ST74099
Folding Screwdriver Set
Key
Ring
Quick
Release
#1 Flat Head
Screwdriver
Metal Screwdriver
Assembly
#2 Flat Head
Screwdriver
#1 Phillips
Screwdriver
#2 Phillips
Screwdriver
Flashlight
On/Off
Switch
Lock/Release
Mechanism
+
-
