Operational Excellence
Page 1 of 3
The information in this leaflet should be passed to the user of the equipment.
This document is issued in accordance with the requirements of DNV 2.7-1 and EN 12079. It outlines the care and safe
use of MUD-SKIPS and is based on the Oil & Gas UK “Best Practice for the Safe Packing & Handling of Cargo to &
from Offshore Locations”. It should be read in conjunction with the instructions for the safe use of Wire Rope Slings.
This information is of a general nature only covering the main points for the safe use of MUD-SKIPS. It may be
necessary to supplement this information for specific operations.
Always
Ensure operators wear appropriate personal protective
equipment (PPE) e.g. gloves, hard hat, safety glasses, and
safety footwear.
Ensure operators are trained and competent.
Ensure dangerous goods are shipped in compliance with the
requirements of the IMDG Code.
Never
Use equipment without carrying out a pre-use inspection.
Use equipment that has not been periodically inspected
and certified.
Replace lifting sets without the approval of a competent person.
Use equipment out with its intended purpose.
Pre-use Inspection
Ensure doors function correctly with hinges and locking gear
free moving and undamaged.
Ensure loading ramps function correctly with hinge bolts and
locking mechanism free moving and undamaged.
Ensure securing devices (bar or ratchet) function correctly with
hinges, cams, pins, etc., free moving and undamaged.
Ensure tie down points are in place and fit for purpose.
Ensure the chain and carabineer are in place and fit for
purpose where applicable.
Ensure the data plate is legible and demonstrates sufficient
certification.
Ensure the safety, identification, and information markings are
clear and legible.
Ensure the lifting set is correctly fitted with shackles and split
pins fully engaged.
Ensure the lifting set is free of obvious signs of damage, e.g.
abrasion, corrosion, wear, chemical attack, and mechanical
damage.
Loading & Operation
To fill the mud-skip with waste drill cuttings use the man-lid or
main lid opening.
When full ensure all lids and man-lids are closed and secured
with locks or ratchet straps where provided.
If vacuum filling/emptying is required ensure the specific unit
is vacuum rated. Do not exceed vacuum rating stated on the
Offshore Container Construction Certificate.
Mud-skips must be emptied and cleaned at an appropriate
drill cuttings process facility.
Empty skip using a rotating forklift or by vacuum pump. Ensure
slings do not restrict the opening lids and that the lid locking
system is open.
Following cleaning and drainage ensure cap is secured on
outlet pipe and all lids are locked in the closed position.
Instructions for the safe use of:
Mud-Skips
