SPECIAL WAtEr
InnovAtIon
Anchor Buoy – Repair Instructions
17: Pull out a length of the belt and
slowly release it while checking
that the belt retracts smoothly and
rolls up onto the belt reel.
18: Insert the assembly into the lower
housing.
Caution: the exit slot is offset! the assem
bly must be inserted so that the exit
guide is in line with the exit slot at the
bottom of the lower housing and the
belt runs straight off the reel through
the slot. the axle will rest evenly in
the saddles at the upper end of the lo
wer housing.
19a: verify proper alignment of the exit
guide with the exit slot in the bottom
of the lower housing and that the axel
is fully seated in the saddles at the
upper end of the lower housing.
19b: Apply the ribbon sealer (Art. 1023)
evenly around the lip of the upper end
of the lower housing.
note: make sure that the ends of the
ribbon sealer are fully connected. If
the mating surfaces of the upper and
lower housing do not form an air-tight
seal then the Anchor Buoy will not
float!
