SPECIAL WAtEr
InnovAtIon
Anchor Buoy – Repair Instructions
13: Push the axle through hub and guide arm until
the retaining collar is seated against the end
plate of the belt reel.
note: you should be able to rotate the axle
freely in the hub. If excessive friction is obser
ved use sand paper to open up the bore in the
hub as necessary.
14a: turn the assembly over and hold between
your knees as shown in the picture.
14b: tighten the M6 self-locking nut previously
installed in step 10.
note: do not over tighten the nut. Check that
the spring coil is free to rotate, otherwise loosen
the nut as necessary.
15: Use a feeler gauge to set the retaining collar to
provide a clearance of 1mm (3/64 in).
note: make sure that the belt reel and spring coil
assembly are able to rotate freely. Increase
the clearance if necessary.
16: Use WD40 or similar spray lubricant to lubrica
te the spring coil.
note: this will improve the service life and per-
formance of the spring coil.
