SPECIAL WAtEr
InnovAtIon
90 mm
Anchor Buoy – Repair Instructions
8a: Use the palm of your hand to secure the spring
coil in place on the hub.
8b: Carefully mount the spring coil onto the spring
coil bearing previously installed on the exit
guide assembly with the machine screw.
note: ensure that the plastic shim is still in place.
9: At this point you no longer need to secure the
coil spring with the palm of your hand. Do not
move the assembly until the next step is com
pleted to prevent the spring coil from becoming
dislodged.
10: Mount the L-shaped guide arm onto the ma
chine screw, install a flat washer and the M6
self-locking nut; do not tighten at this time.
11: At this point the spring coil is secured and the
assembly can now be moved as necessary
to accomplish the next steps in the
assembly procedure.
12a: Grasp the assembly with your left
hand as shown in the picture holding the
guide arm and the spring coil at the same
time.
12b: Insert the axle from the right hand side
as shown in the picture.
