©2022 SwellPro All Rights Reserved
32
For SN number ending with V01
To pair
1.
Turn over the aircraft and place it on the carrying case. Unscrew and take off the
bottom plate.
2.
Turn on both the aircraft and remote control. Wait for 1 minute until the right LED
light turns from flashing to solid.
3.
Long press the pair button for 10 seconds. (Do not press shorter than 10
seconds) The right LED will start flashing.
*If the right LED does not flash, please
repeat the step until the right LED starts flashing.
4.
Wait for 1 minute until both the left and right LED turn solid. The reset process is
complete.
5.
Now, long press the aircraft’s pair button for 5
-10 seconds. (Do not press shorter
than 5 seconds) The right LED will start flashing.
*If the right LED does not flash,
please repeat the step until the right LED starts flashing.
6.
Quick press the remote control’s pair button
twice
. Wait for 5 seconds. The left
and right LED will flash alternatively.
•
*If the left and right LED do not flash alternatively in 10 seconds, please
repeat this step again until the left and right LED flash alternatively.
•
*If the left LED does not flash and the right LED has already turned solid.
Please repeat the pairing process again from step 1.
7.
The pairing process can take up to 3 minutes. When the pairing process is
complete, the right LED will turn from flashing to solid, and the left LED will stay
flashing. The remote controller will prompt “Aircraft initializing, please wait”.
8.
Assemble the bottom plate back, turn over the aircraft and place it on a level
surface. The
“Aircraft initializing, please wait” prompt will disappear in 30
seconds, and you are now ready to fly.
If the pairing process does not succeed, please try to pair them again from step 1.
