7
Inserting Batteries and an SD Card
Undo the two clips on the side of the
OutbackCam
and open the case. Before
inserting batteries or an SD card,
ensure that the
OutbackCam
is turned OFF.
To install/change batteries:
Locate the battery slots, on the rear of the camera unit.
•
Remove any old batteries.
•
Insert new ones observing the polarity shown in the battery slots.
•
Use only fresh batteries. Do NOT mix battery types.
•
You may need to re-configure the
•
OutbackCam
when you swap batteries.
To insert an SD card:
If there is an SD card in the slot already, remove it. To release the SD card, push
•
it into the slot for a moment then release, and it will ‘pop’ out.
Face the SD card so that the data connectors are face down, with the 45° cut
•
corner orientated to the top right hand side.
Attaching the Strap
The included strap can be used to attach the
OutbackCam
to any structure which the strap can fit around. Ensure
you have the required components. You’ll need the fabric
strap, and the two halves of the clasp (pictured clipped
together, facing “top-side” up).
Feed the fabric strap through the two spaces
1.
provided on the rear of the
OutbackCam
. Un-clip
and separate the two halves of the clasp.
Feed one end of the strap though the bottom side
2.
of the second hole of one clasp, as pictured to the
left.
Loop the end of the strap back through the first slot
3.
in the clasp, as shown to the left.
Repeat for the other half of the clasp. To tighten
4.
the strap, simply pull on the loose ends of the strap
protruding from the clasp. If you find that the strap
slips out of one or both ends of the clasp, then this
indicates that the clasp is upside-down.
Mounting the
OutbackCam
