NOTE
For easy installation of final supply line connections, it
is suggested that, if possible, plumbing connection to
faucet be made at this point. Plumbing connections to
hot and cold supply line can then be made after sink
is secured to counter top.
Read ALL instructions carefully BEFORE starting your installation
CAPACITY 7 GALLONS
1. Measure and cut counter hole for sink insertion 15-7/8” wide x
18-5/8” long. Test fit sink. File any areas which require widening.
2. After test fitting sink, remove from counter hole and install faucet
(not included) and drain assembly (not included). A standard
3-1/2” drain assembly is recommended.
3. Caulk along edges of 15-7/8” x 18-5/8” counter hole with 1/8”
bead of silicone or latex caulk (not included).
4. Set sink into place and assemble (see Figure 1). Alternate from
one threaded bolt to another until all bolts are tight.
5. Some caulking residue may flow from under sink flange. This
residue can be wiped clean following instructions on silicone
or latex caulking tube.
6. Attach drain waste and faucet plumbing.
Installation Procedure for
MODEL SSUS2000
SWANSTONE UTILITY SINK
IMPORTANT
It is recommended that a standard
3-1/2” drain assembly (not included)
be used to complete the installation
of the Swan DIT-S self-rimming
drop-in Tub.
TO BE REMOVED FOR USE BY OCCUPANT
Swan
C O R P O R A T I O N
of the Swan SSUS2000.
3 3/4”
8
3/4”
10 1/2”
