www.swstahl.de
SW-Stahl GmbH
An der Hasenjagd 3
D-42897 Remscheid
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: [email protected]
B
E
D
IE
U
N
U
N
G
S
A
N
L
E
IT
U
N
G
/
IN
S
T
R
U
C
T
IO
N
M
A
N
U
A
L
20320L
Feature
•
Used for parts straightening, bending and pressing.
•
Multi-position bed for work height adjustment.
•
With air pump can reduce labor and improve working efficiency
Warning
•
This press is designed and intended for use by properly trained and experienced
personnel only. If you are not familiar with the proper and safe operation of a hydraulic
press, do not use until proper training and knowledge has been obtained.
•
Do not operate this press beyond it rated capacity.
•
DO NOT compress springs or other objects that could be ejected from the press. DO
NOT compress objects that could shatter.
•
Please understand the max. working stroke before operate, Do not overload the max.
working stroke, so as not to damage parts.
•
Check the press for loose or damaged parts before each operation. Replace damaged
parts and tighten all loose bolts before operating.
•
Some parts being pressed may have a tendency to pop out of the press or explode under
pressure. Protect yourself accordingly.
Manual
1.
Place work piece on bed frame.
2.
Locate and close release valve.
3.
Pump handle until the ram nears work piece.
4.
Apply load to work piece by pumping handle. Do not overload work piece.
5.
Remove load from work piece by turning release valve. Stabilize work piece so it does
not fall while pressure is released.
6.
Remove work piece after ram is fully retracted.
Maintenance
•
Periodically, lightly oil all moving parts including the pump piston and hydraulic ram.
•
Check hydraulic connections and hoses before each use.
•
Do not use if cut, damaged, leaking or otherwise damaged connections and/or hoses are
noted
