SVS-Vistek SHR 10GigE, Manual

Page: 64 / 103

5.2.11 Predefined configurations (user sets)
The camera starts with default values for all features when turned on. Settings
made during operation will expire when the camera is turned off.
All preset adjustments are located in the GenICam tree in the “User Set Control”
property. It is possible to save up to 8 user sets. Each of these setups consists of
a complete configuration set including exposure time, delays, I/O configuration for
the camera. These user sets can be loaded at runtime. In addition, you can spe-
cify which setup is loaded as default when the camera is switched on.
Load a user set
With UserSetSelector a user set can be selected. Select the desired user set and
press UserSetLoad (command) twice to load the user set. The following example
loads user set 2.
Save user sets
Select the user set to be saved in the UserSetSelector and save it with the User-
SetSave command.
Set a user set as default
Use User Set Default to select the user set that is to be loaded when the camera
is started. Save this setting with UserSetSave (In the example below, user set 5
is saved as default).
Reset to factory default
User sets can be reset to factory settings. This is a two-step process. First, the
factory settings must be loaded:
5 Feature description 64