SVS-Vistek SHR 10GigE, Manual

Page: 11 / 103

3.3.2 Connect the camera
The camera is powered on by connecting power to to the camera. Connect the
power supply with the Hirose connector. When using your own power supply
(voltage range 10 -25 V DC) see also Hirose™ 12-Pin layout of the power con-
nector. For power input specifications refer to specifications.
Generally external power supply for USB3 Vision, CoaXPress (if PoCXP
enabled) or PoE cameras is not needed. Nonetheless, you might want to use a
separate power on the Hirose connector to reduce load on the data port. The
external power on the Hirose connector is the preferred power source.
The power up is defined as follows:
l
Power over USB3, CoaXPress port or GigE port (with PoE) or on the Hirose
connector will power on the camera
l
If power is found on the Hirose connector, camera power supply will switch
to the Hirose connector
l
If Hirose power supply is cut, camera power supply will switch back to power
over USB3, PoE or power over CXP supply
INFO Camera power supply is not powering 4I/O LED lights.
When using your own power supply (voltage range 10-25 V DC) see also Hirose
12- pin layout of the power connector. For power input specifications refer to spe-
cifications.
3.4 Camera status LED codes
On power up, the camera will indicate its current operation status with a flashing
LED on its back. The LED will change color and rhythm.
The meaning of the blinking codes translates as follows:
Fig.: 3-1: Camera status LED codes
3 Getting started 11