SVP UDT-4K, Manual

Page: 30 / 193

UDT-4K UHD HEVC Digital Camera Transmitter
MANUAL V0
30
4.3.3 Cross Button
This button is used to:
• Enter from the equipment main screen to the setup menu and vice
versa.
• Exit equipment’s submenus.
•
This button allows the user to access the main screen from the alarms
screen.
Figure 4.6: Cross button
4.3.4 Left and Right Button
These buttons are used to:
•
To move the cursor towards the digit immediately on the left or right
and to select a parameter from different options.
Figure 4.7: Left and Right buttons
4.3.5 Up and Down Button
•
The up and down arrow buttons allow the navigation on the main menu
and the rest of submenus. Using these buttons, the user can enter to
the submenu or change a parameter. Once selected, the OK button must
be pressed.
•
These buttons are also used to change, for example, the frequency and
PID parameter’s values. Pressing up and down arrows the value of those
parameters can be changed, increased or decreased respectively.
Figure 4.8: Up and Down buttons
4.3.6 RF Button
By pressing the RF button, RF output is enabled or disabled. The RF LED
indicates the status of the RF output. It is important that before pressing this
button, the selected RF output must be conveniently loaded and there is no
reflected signal.
In case the device is switched off with the RF output enabled then, when it is
switched on again it is necessary to push again this button to enable this
feature.