SVP UDT-4K, Manual

Page: 28 / 193

UDT-4K UHD HEVC Digital Camera Transmitter
MANUAL V0
28
4.2 LEDs
The UDT-4K Transmitter has 5 LEDs on its front panel that show the
information detailed below.
Figure 4.2: UDT-4K front panel LED indication
The ON/OFF provides the following information:
•
If the LED is off, the equipment is not being fed.
• If the LED flickers in red, the equipment is being fed but it is turned off.
• The Led lights up in green when the equipment is turned on.
The RF LED provides the following information:
• If the LED is off, the equipment does not transmit RF signal.
• The LED lights up in green when the equipment transmits RF signal, RF
stage is active.
The ALARM LED provides the following information:
•
The LED lights up in red when any alarm occurs.
•
The different alarms that can appear in the transmitter are:

Voltage High.

Voltage Low.

Temperature High.

ASI Overflow: This alarm means that the input bitrate is higher
than the one that can be modulated due to the configured
parameters (constellation, FEC, GI...).
•
The different warnings that can appear in the transmitter are:

No SDI/HDMI/CVBS/ASI Input.

No GPS.

No KLV.
The REMOTE LED provides the following information:
• The LED lights up in blue when the user is connected remotely to the
device (through the Web Server).
The STATUS LED provides the following information:
• The LED lights up when the encoder is working properly.
ON/OFF
RF
ALARM
REMOTE
STATUS