Svantek SVAN 979, User Manual

Page: 88 / 377

88
SVAN 979 User Manual
•
Sim Auth Mode
– defines the method of user verification by a SIM card type.
Depending on the SIM card, several options are possible, some of them are
recognized by the modem:
•
none
– no verification required.
•
PAP
•
CHAP
•
MsChap
– denotes MsChap in version 1.
•
Send SMS
– selecting this option will enable SMS alarm notifications.
•
Send E-Mail
– selecting this option will enable e-mail alarm notifications.
•
Auto Reconnection
– selecting this option will make the device attempt to
reconnect the modem in case of errors or sudden disconnection.
•
Reconnection Delay
– defines time between each reconnection attempts.
•
TCP IRT - defines TCP Initial Retransmission Timeout. In some cases,
extending this timeout may be helpful in case of slow connections, but the
default setting is recommended.
•
TCP Max. Ret. - defines maximum reconnection attempts performed within
a simple connection cycle. In some cases, setting higher value may be helpful
in case of slow connections, but the default setting is recommended.
7.17.4
Configuring connections
– Modem Connection
The Modem Connection position allows
you to configure several parameters to
establish internet connection.
<ENT>
Note: For connection with the SvanNET server the parameters in the Modem Connection list
should be set on default values as is shown on the screenshots above and below.
The Modem Connection screen contains the following positions:
•
Server Address
– allows you to enter up to 32 characters of either IP or
domain address, where the registration data will be sent during the
registration process (
Data Protocol: TCP S or UDP ) or to which the modem
will connect to ( Data Protocol: TCP C) . By default, the server address is
app.svannet.com and all other settings, presented in this chapter, are
default settings, which enabled the connection with the SvanNET server.
•
Data Port
– allows you to enter up to 5 characters for the port number. This
number denotes a port on which a communication socket will be configured
for data exchange between the remote host and the station.
•
Registration Port
– allows you to enter up to 5 characters for the port
number. This number denotes a port on which a communication socket will
be configured to transmit registration package (Register Mode: On) or
exchange Http data (Register Mode: AS or SMT. AS).