Svantek SV 971A, User Manual

Page: 33 / 305

SV 971A User Manual
33
4 CONFIGURING MEASUREMENT PARAMETERS
– Measurement
The Measurement section combines elements related
to measurement parameters configuration.
To open the Measurement section, press the <Menu>
key, select the Measurement position and press
<Enter> .
<ENT>
The content of the Measurement list depends on the
Interface mode ( Simple and Advanced ) and
Measurement Function . Some example screens for
Advanced and Simple modes are presented.
The Measurement section contains following positions:
General Set allowing you to set general measurement parameters;
Meas. Trig. allowing you to configure the measurement trigger. This position appears only
in the
Advanced interface mode;
Profiles allowing you to set parameters specific for the profile. This position disappears
in the
Dosimeter function;
Profile 1 (2,3) allowing you to set parameters specific for profiles in the Dosimeter function.
These positions appear only in the Dosimeter function instead of Profiles ;
Alarm allowing you to programme the alarm function. This position appears only in the
Dosimeter function and the Advanced interface mode;
Logging allowing you to configure the logging function;
Spectrum allowing you to set spectrum parameters. This position becomes available only
in the 1/1- and 1/3-octave analysis functions;
Range allowing you to set the required measurement range;
Comp. Filter allowing you to switch on the required compensation filter. This position appears
only in the
Advanced interface mode;
Stat. Lev. allowing you to define 10 statistical levels;
Exp. Time allowing you to set the exposure time for dose measurements. This position
appears only in the
Dosimeter function and Advanced interface mode;
Timer allowing you to programme the internal timer. This position appears only in the
Advanced interface mode.
4.1 S
ETTING GENERAL MEASUREMENT PARAMETERS
–
G
ENERAL
S
ETTINGS
The General Set screen allows to programme general
measurement parameters: delay of the measurement
start of (
Start Delay ), synchronisation with the
instrument’s RTC (
Start Sync. ), integration period/
measurement run time ( Integr. Per ), repetition of
measurement cycles ( Rep. Cycles ), LEQ detector type
( LEQ Integr. ) and duration of day periods
( Day Time L. ).
<ENT>