SV 104A USER'S MANUAL_______________________________________________________
32
4.4
Battery check
Observe the battery icon in the instrument’s icon status bar or press the
<ENTER>
key until
the Instrument Status view mode is presented and check the battery state. If it is too low, charge the batteries
(chapter 4.1).
Figure 4-3 Instrument Status - Battery state
Battery status screen is moved down and up with
<SCROLL>
,
<PROFILE>
keys.
Press
<ENTER>
to change to the next
VIEW
mode.
Note: Battery state of charge calculation is based on internal charge counter and should be
considered only as an overall, not very precise estimation. Therefore the time left could be noticeably
different. Although the newest technology cells are used the slight degradation over time is inevitable thus
aging requires occasionally factory based (or authorised service centre) replacement of the rechargeable
battery cells.,
Note: Battery power indicator - To improve accuracy of remaining battery life indicator, run
the dosimeter until it is fully discharged; then proceed with a full charge via the micro USB port or docking
station. The procedure is recommended before first use. Repeat this procedure every few months of use
to maintain more accurate current battery condition indication.
4.5
Reviewing unit label
Unit label screen provides information about elementary dosimeter properties such as:
•
Copyrighted manufacturer name:
SVANTEK (C)
•
Instrument name:
SV 104A
•
Unit serial number:
SN XXXXX
•
ST 104A microphone serial number:
SN ST104A XXXXX
•
Unit name:
XXXXXXX
[user programmable name]
•
Firmware version:
Version X.XX.X
•
File system version:
FS Version X.XX
•
CRC value:
CRC(OK) XXXX
•
Standards list, that dosimeter conforms to:
o
IEC 61252:2002
o
ANSI S1.25:1991 (R2007)
o
Class 2: IEC 61672:2013
o
Class 1: IEC 61260:1995
[with +Am1 2001]
To access Unit Label screen short press all three keys:
<SCROLL>
,
<PROFILE>
and
<ENTER>
at the same time.
