Suzuki Wagon R RB310, Supplementary Service Manual

Page: 148 / 254

IMMOBILIZER CONTROL SYSTEM 8G-3
Procedure after immobilizer control module replace-
ment
[When using Tech 1A]
For the procedure, refer to “Procedure after immobilizer control
module replacement” in the same section of the Service manual
mentioned in FOREWORD of this manual.
[When using Tech 2]
1) Perform IMMOBILIZER SYSTEM COMPONENTS REGIS-
TRATION FLOW TABLE.
2) Connect Tech 2 to DLC with ignition switch at OFF position.
3) Turn ignition switch to ON position.
4) Select “Registration” at mode select screen under Immobi-
lizer.
5) Perform immobilizer control module registration by selecting
“IMMO Cont (Regi secret key code)”.
6) After completing immobilizer control module registration,
register ignition key (fix code) into immobilizer control mod-
ule by performing “Register New Ig Key (Fix Code)” at Immo-
bilizer Registration Menu.
Procedure after ECM replacement
[When using Tech 1A]
For the procedure, refer to “Procedure after ECM replacement” in
the same section of the Service manual mentioned in FORE-
WORD of this manual.
[When using Tech 2]
1) Perform IMMOBILIZER SYSTEM COMPONENTS REGIS-
TRATION FLOW TABLE.
2) Connect Tech 2 to DLC with ignition switch at OFF position.
3) Turn ignition switch to ON position.
4) Select “ECM (Regi SKC/PWD)” at Immobilizer Registration
menu”.
NOTE:
For operation procedure of scan tool, refer to operator’s
manual.
Immobilizer registration menu
F0: Register New Ig Key (Fix Code)
F2: ECM (Regi SKC/PWD)
F1: IMMO Cont (Regi Secret Key Code)
Immobilizer registration menu
F0: Register New Ig Key (Fix Code)
F2: ECM (Regi SKC/PWD)
F1: IMMO Cont (Regi Secret Key Code)