Suzuki Wagon R Plus RB310, Service Manual

Page: 564 / 846

MANUAL TRANSAXLE (M13 ENGINE) 7A2-41
Differential Disassembly and Assembly
Disassembly
1) Using special tools, remove right bearing (1) and sensor
rotor (2).
Special tool
(A): 09913-60910
(B): 09925-88210
2) Remove left bearing in the same manner at step 1).
3) Support differential case with soft jawed vise and remove
final gear bolts then take out final gear.
4) Using special tool and hammer, drive out differential pinion
shaft pin and then disassemble component parts.
Special tool
(C): 09922-85811
Assembly
1) Drive in new differential pinion shaft pin (2) till the depth from
differential case (3) surface is about 1 mm (0.04 in.).
2) Press-fit new sensor rotor (1) with groove (4) side downward
as shown using special tools and copper hammer.
Special tool
(A): 09913-75510
(B): 09940-54910
3) Press-fit left bearing (2) using special tools and copper ham-
mer.
4) Support differential assembly (1) as illustrated so as to left
bearing (2) is floating, and then press-fit right bearing (3) like
left bearing in Step 3).
Special tool
(C): 09951-76010
(D): 09951-16060
1. Differential case
2. Differential gear
3. Differential pinion shaft