Suzuki VLR1800, Service Manual

Page: 472 / 624

3A-14 Drive Chain / Drive Train / Drive Shaft:
2) Apply moly paste to the propeller shaft spline.
: Moly paste 99000–25140 (SUZUKI MOLY
PASTE or equivalent)
3) Install the final gear case assembly.
NOTE
To install the final gear case easily, move the
dust boot front and the universal joint turn
into the propeller shaft.
4) Install the washers (1) and tighten the final gear case
nut (2) to the specified torque.
NOTE
The conical side of the washer (1) faces
outside.
Tightening torque
Final gear case nut (a): 40 N·m (4.0 kgf-m, 29.0
lb-ft)
5) Tighten the final gear case pivot bolt (3).
6) Install the rear wheel assembly. Refer to “Rear
Wheel Assembly Removal and Installation in Section
2D (Page 2D-11)”.
7) Pour final gear oil. Refer to “Final Gear Oil
Replacement in Section 0B (Page 0B-14)”.
Final Gear Disassembly and Assembly
B822H13106016
Refer to “Final Gear Assembly Removal and Installation
(Page 3A-13)”.
Disassembly
1) Remove the stopper plate (1).
2) Remove the dust seal (2).
I822H1310044-02
I822H1310045-01
1
(a)
2
1
3
I822H1310046-05
1
I822H1310047-01
2
I822H1310048-01